Min.Order : 15 Pieces Quick Quotation >
Item Details
Product Description
A Drop-In anchor consists of a tubular expansion shield and a solid, cone-shaped expander plug. The expander plug is case hardened and tempered to prevent galling and binding during expansion. The shield has four equally spaced slots for a portion of its length, the bottom part may be knurled. The shield also has a smooth, flangeless top that allows either flush or countersunk installation. the bottom lip of the shield is tapered to allow maximum depth and holding power.
DROP-IN ANCHORS
Anchor Size/ | Hole Diameter | T | Minimum | Ultimate Tensile (lbs.) | Ultimate Shear (lbs.) | ||
Bolt Size | Thread Length | Embedment | 4000 psi. Concrete | ||||
1/4 | 3/8 | 1/2 | 1 | 2067 | 1321 | ||
3/8 | 1/2 | 5/8 | 1 | 9/16 | 3995 | 3714 | |
1/2 | 5/8 | 3/4-1 3/16 | 2 | 4110 | 5854 | ||
5/8 | 7/8 | 1-1 3/16 | 2 | 1/2 | 5750 | 8754 | |
3/4 | 1 | 1 3/16-1 1/4 | 3 | 3/16 | 10807 | 11627 | |
A two-piece, internally threaded expansion anchor with four equally-spaced longitudinal slots extending from the | |||||||
bottom end of the outer | |||||||
Description | shield, inside of which sits a pre-assembled dilating plug. The bottom lip of the anchor is tapered. It is permissible | ||||||
for a section of the | |||||||
shield to be knurled, to increase the gripping action of the anchor. | |||||||
Intended for flush mounted, medium to heavy-duty applications in solid materials such as stone and concrete. It | |||
Applications/ | can be used in, but are | ||
not limited to, overhead assemblies such as duct work and pipe hangers because the internal plug holds its | |||
Advantages | |||
position. Can also be used | |||
to anchor handrails and floor-mounted door stops. | |||
Steel | 18-8 Stainless | ||
Material | Anchor body: AISI 12L14 cold rolled steel | ||
Expander Plug: AISI 12L14/1215 cold rolled steel, | Anchor body: 303 Stainless steel | ||
case-hardened | Expander Plug: 303 Stainless steel | ||
and tempered | |||
Anchor Spacing | Anchors should be installed a minimum of ten anchor diameters between each other and a minimum of five anchor | ||
diameters from the edge. | |||
Depth of Hole | Should be at least equal to the length of the anchor. | ||
Tensile and | The suggested safe working load is one-fourth the average proof test loads shown in the above table. | ||
Shear | |||
Strengths | |||
Payment & Shipping
More Product
Recommend Product